A sagging entry door is hard to ignore — it scrapes the threshold, whistles at the lock side, or simply will not close without a hip check. In Richmond Hill, hinge repair and adjustment fix many of these problems without replacing the slab.
Search terms like fix sagging door and door won't close often point to the same root cause: loose hinge screws, worn pins, or a door hung slightly out of plumb after settlement or flooring work.
Signs you need door hinge repair
- Gap wider at the top or bottom of the latch side
- Door binds on the threshold or carpet
- Latch misses the strike — rub marks above or below the hole
- Hinge screws spin or pull out of the jamb
- Door won't close fully unless lifted or pushed hard
- Cold air at the hinge side even when latched
Why doors sag in Ontario homes
Weight, traffic, and seasonal movement all stress hinges. Short screws that only bite into trim pull out over time — especially on Richmond Hill entries with heavy fiberglass or steel slabs.
House settling after renovation or new flooring can change how the slab meets the frame. A door that closed fine last year may need hinge shims or longer screws this season.
Repair steps that hold
We tighten or replace hinge screws with longer fasteners into the stud where possible. Bent or cracked hinge leaves get swapped. Shims behind the hinge plate correct minor plumb errors without re-hanging the whole door.
When the latch still misses after hinge work, we adjust or rebuild the strike area — hinge repair and strike alignment often go together on the same visit.
When to call Hillcrest Door Repair
If the door won't close, won't latch, or drags on the floor, treat it as a security and efficiency issue — not just an annoyance. Hillcrest Door Repair handles door hinge repair across Richmond Hill, Thornhill, Oak Ridges and nearby York Region.
Call (647) 560-1270 or send photos of the hinge side gap and strike area. Many sagging door repairs finish in one visit when the jamb is still solid.
Common questions
Quick answers to what homeowners and property managers ask most about this problem.
Why won't my door close all the way in Richmond Hill?
Often the door has sagged on its hinges so the latch side binds on the threshold or frame. Loose screws, worn hinge pins, or settlement after renovation are common causes. Hinge adjustment and strike realignment usually fix it when the jamb is sound.
Can longer hinge screws fix a sagging door?
Longer screws into the stud help when the jamb wood is still solid. If screws spin freely or the hinge side is split, rebuilding that section comes first — otherwise the door sags again within weeks.
Is door hinge repair cheaper than a new door?
Yes, when the slab and frame are sound. Hinge work, strike adjustment, and weatherstripping tune-up cost far less than a full entry replacement. We inspect on site before recommending either path.
Does a door that won't latch need hinge repair or lock repair?
Both can be involved. Sagging hinges change where the latch meets the strike. We check hinge side gap first, then the strike plate. Fixing hinges alone often restores latching without new lock hardware.
Need door repair in Richmond Hill?
Hillcrest Door Repair serves Richmond Hill, Thornhill, Oak Ridges, Aurora, and nearby York Region. Call (647) 560-1270 or request a quote with photos of the door — we will tell you honestly whether repair makes sense.